The foundation of the Model Support System the base is a T shaped piece into which the various supports plug in and out.

The top and stem of the T are each 22.5cm long.

The base can be extended with additional bases, and short or long extension bases. There are connector pieces available for joining bases together.

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Model Support System - Base

Qty

A set of short wing and fuselage supports for supporting smaller model aeroplanes on the Model Suppo..

£4.00

A set of tall wing and fuselage supports for supporting larger model aeroplanes on the Model Support..

£6.00

A short, 110mm extension for the base of the Model Support System. This also forms a base for ..

£2.00

A long, 230mm extension for the base of the Model Support System. This also forms a base for t..

£3.00

Connector piece for firmly joining two bases or extension pieces together...

£2.00

The Wing Support is designed to restrain the wing tip when an aircraft is setup in a Tilted Fuselage..

£3.00

A set of four adjustable supports in two pairs. Aimed at small and medium 1:72 models these wi..

£8.00

A pair of larger, reinforced supports. During development these have been used to support a Re..

£9.00